ABCDV网站

 找回密码
 立即注册

QQ登录

只需一步,快速开始

查看: 742|回复: 3

求助工程热力学

[复制链接]
发表于 2004-11-27 14:01:42 | 显示全部楼层 |阅读模式
马上要审核了,寻找过经典贴了,可是没有找到工程热力学的材料,听说有段很精彩的总结,可硬是没有看到。哪位大人好心有材料的贴一下了,小弟在此先谢过了。
发表于 2004-11-27 21:15:22 | 显示全部楼层
Power plants generate electrical power by using fuels like coal, oil or natural gas. A simple power plant consists of a boiler, turbine, condenser and a pump. Fuel, burned in the boiler and superheater, heats the water to generate steam. The steam is then heated to a superheated state in the superheater. This steam is used to rotate the turbine which powers the generator. Electrical energy is generated when the generator windings rotate in a strong magnetic field. After the steam leaves the turbine it is cooled to its liquid state in the condenser. The liquid is pressurized by the pump prior to going back to the boiler A simple power plant is described by a Rankine Cycle.

RANKINE CYCLE(图略)
Saturated or superheated steam enters the turbine at state 1, where it expands isentropically to the exit pressure at state 2. The steam is then condensed at constant pressure and temperature to a saturated liquid, state 3. The heat removed from the steam in the condenser is typically transferred to the cooling water. The saturated liquid then flows through the pump which increases the pressure to the boiler pressure (state 4), where the water is first heated to the saturation temperature, boiled and typically superheated to state 1. Then the whole cycle is repeated.


REHEAT(图略)
When steam leaves the turbine, it is typically wet. The presense of water causes erosion of the turbine blades. To prevent this, steam is extracted from high pressure turbine (state 2), and then it is reheated in the boiler (state 2') and sent back to the low pressure turbine.

REGENERATION(图略)
Regeneration helps improve the Rankine cycle efficiency by preheating the feedwater into the boiler. Regeneration can be achieved by open feedwater heaters or closed feedwater heaters. In open feedwater heaters, a fraction of the steam exiting a high pressure turbine is mixed with the feedwater at the same pressure. In closed system, the steam bled from the turbine is not directly mixed with the feedwater, and therefore, the two streams can be at different pressures.

COMPONENTS
Boiler/Superheater
Condenser
Turbine
Pump

thermal efficiency=net power out /heat in
回复 支持 反对

使用道具 举报

发表于 2004-11-27 21:18:39 | 显示全部楼层
the stuffs are just a little bit of total course,not enough,^_^
回复 支持 反对

使用道具 举报

 楼主| 发表于 2004-11-27 22:36:01 | 显示全部楼层
回复 支持 反对

使用道具 举报

您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

小黑屋|手机版|Archiver|ABCDV网站,版权所有:北京佳景时代文化有限公司 ( 京ICP备19037940号-1 |||| 京公网安备11010802012322 |||| 工信查询网址: https://www.beian.miit.gov.cn )

GMT+8, 2025-12-18 19:51 , Processed in 0.082918 second(s), 15 queries , Gzip On.

Powered by Discuz! X3.4

Copyright © 2001-2021, Tencent Cloud.

快速回复 返回顶部 返回列表